The Handloaders Bench Home

Search
   
Members

Calendar

Help

Home
Search by username
Not logged in - Login | Register 


125 grain LSWC bullets for .38 Special.
 Moderated by: klallen  

New Topic

Reply

Print
AuthorPost
sunnyf16
HB Full Member
 

Joined: 17 July 2008
Location:  
Posts: 9
Photo: 
Are you a handloader?: Yes
Favorite type of cartridge to load?: pistol
Status:  Offline
 Posted: 21 July 2008 04:54 AM

Quote

Reply
Good evening,

I have a loading question I hope somebody can help with. I recently acquired a box(500) of .125 Gr. Lead wadcutters. They look just like a normal 158 Gr LSWC, but weigh less. I cannot find any loading data for this bullet. I would like to shoot them out of a short barreled revolver as practice rounds for the more expensive Hornady XTP's.

I have looked at all the major publications and cannot find anything referring to these bullets.

Am I looking in the wrong place or does anyone have a load for this.

Thanks,

P.S. My powder of choice is 700x, but will entertain anything.

Thanks again.

Rockydog
addicted handloader


Joined: 26 July 2005
Location: Wisconsin USA
Posts: 436
Photo: 
Are you a handloader?: Yes
Favorite type of cartridge to load?: I load everything!
Status:  Offline
 Posted: 21 July 2008 05:15 AM

Quote

Reply
Sunny, Try here http://stevespages.com/357p_7_125.html He lists 125 grain bullets, not necessarily your specific bullet, but if you are shootong lead you should be just fine. RD



____________________
"Those who hammer their guns into plows will plow for those who do not." ~ Thomas Jefferson ~

Charley
Administrator


Joined: 9 September 2005
Location: San Antonio, Texas USA
Posts: 2207
Photo: 
Are you a handloader?: Yes
Favorite type of cartridge to load?: I load everything!
Status:  Offline
 Posted: 21 July 2008 12:37 PM

Quote

Reply
Hodgdon's website shows between 3.7 and 4.2 grains of 700X with a 125 grain cast lead RNFP. Your bullet should be very similar.

http://data.hodgdon.com/main_menu.asp



____________________
"You all can go to Hell, I'm going to Texas" David Crockett (and probably George Bush)
Dirtkicker
addicted handloader


Joined: 3 September 2007
Location: High Plains
Posts: 334
Photo: 
Are you a handloader?: Yes
Favorite type of cartridge to load?: I load everything!
Status:  Offline
 Posted: 21 July 2008 03:40 PM

Quote

Reply
I've used full w/c bullets in .38s down to 100 grains. They're not nearly as accurate as the old 148 grain HBWCs. They make a pretty good small game bullet though.

sunnyf16
HB Full Member
 

Joined: 17 July 2008
Location:  
Posts: 9
Photo: 
Are you a handloader?: Yes
Favorite type of cartridge to load?: pistol
Status:  Offline
 Posted: 22 July 2008 04:32 AM

Quote

Reply
Thanks for the links. I knew I would find the information on this board. I did not even think about the Hodgdon site. It had information that I think I can use. Its funny that the Hodgdon book I picked up at Sportsmans Warehouse did not have everything that the website has.


Thanks for all the help.

Charley
Administrator


Joined: 9 September 2005
Location: San Antonio, Texas USA
Posts: 2207
Photo: 
Are you a handloader?: Yes
Favorite type of cartridge to load?: I load everything!
Status:  Offline
 Posted: 23 July 2008 03:11 AM

Quote

Reply
sunnyf16 wrote: Thanks for the links. I knew I would find the information on this board. I did not even think about the Hodgdon site. It had information that I think I can use. Its funny that the Hodgdon book I picked up at Sportsmans Warehouse did not have everything that the website has.


Thanks for all the help.


That's 'cause print is dead! I do buy some current reloading guides, but I do get a lot more information from manufacturer's websites for the most part.

That noise you hear is J. Guttenberg spining in his grave.



____________________
"You all can go to Hell, I'm going to Texas" David Crockett (and probably George Bush)

 Current time is 11:02 PM




Powered by WowBB 1.7 - Copyright © 2003-2006 Aycan Gulez