| Posted: Sun Oct 25th, 2009 04:57 AM |
|
21st Post |
sako06
Moderator
| Joined: | Sun Jul 22nd, 2007 |
| Location: | California USA |
| Posts: | 821 |
| Photo: | | | Are you a handloader?: | Yes | | Favorite type of cartridge to load?: | I load everything! | | My favorite chambering is:: | |
| Status: |
Offline
|
back to top
|
In the early 1970's I purchased an OHAUS DUO 7200 Powder Measure that I've used for handgun and rifle loads in fact I installed it on my Dillon RL450 & then on my Dillon RL550B I've used it for:30-06,300wm,45-70,32-20,243,38spec,357mag,45acp,sw460mag,454casull,45colt &41mag.I bought another on ebay but haven't used it.This is a very accurate powder loader.In the 1960's & 1970's this cost twice as much as any powder loader on the market,it was sold to RCBS who discontinued production.
|
| Posted: Sun Oct 25th, 2009 05:09 AM |
|
22nd Post |
miestro_jerry
Administrator
back to top
|
How about a Belding Mull powder dispenser? I have one on my bench.
Jerry
____________________
No Goats, No Glory
NRA Benefactor Member
Ohio Rifle and Pistol Association Member
The Cast Bullet Association
Bethesda Farmers and Sportsmen Club
ODNR Certified and Licensed Hunter
|
| Posted: Sun Oct 25th, 2009 02:26 PM |
|
23rd Post |
sako06
Moderator
| Joined: | Sun Jul 22nd, 2007 |
| Location: | California USA |
| Posts: | 821 |
| Photo: | | | Are you a handloader?: | Yes | | Favorite type of cartridge to load?: | I load everything! | | My favorite chambering is:: | |
| Status: |
Offline
|
back to top
|
Jerry I located my Lyman Shotshell 3rd Edition with RXP data.Winchester 452AA is now Titegroup;Winchester win540 is HS6(my favorite powder doesn't blow patterns) Win 571 was HS7 but neither are made any longer. Win 473AA was replaced by Superfield.I'm waiting for some Longshot load data a hodgden tech told me he'd send? I was on midwayusa checking out magtech all copper 95grain 38/357 bullets they are out of 357 @ $44.99 but they have 38 special 95grain all copper bullets for $50.99 per 100 these are the exact same bullet with different id codes so everyone bought the 357mag 95 grain bullets. I have the following 100 round bags of magtech all copper bullets:357,45auto 165gr( should go ok in my 45colt) & 454 225gr( 45colt ruger bh,454casull tc encore 15inch pistol and sw460mag bullberry 20 inch encore rifle barrel.
|
| Posted: Sun Oct 25th, 2009 04:31 PM |
|
24th Post |
miestro_jerry
Administrator
back to top
|
Sako,
Thanks, I do have some HS6 on hand not enough for a big run, but enough to have fun with.
Thanks,
Jerry
____________________
No Goats, No Glory
NRA Benefactor Member
Ohio Rifle and Pistol Association Member
The Cast Bullet Association
Bethesda Farmers and Sportsmen Club
ODNR Certified and Licensed Hunter
|
| Current time is 09:18 AM | Page:   1 2 |
|
