I have purchased a considerable amount of Lee equipment and all has been good until now. l received my new Lee 125 grain mold for my 357 mag revolver and that is where the wheel started to leave the rail..
The mold was backordered from Midway for several weeks and then when it arrived it case boolits at .364" and they were 131 grains.
I contacted Lee and they said send it back and it would be repaired or replaced. I did send it back immediately and then called after a a week.
I'm now being told they may get to it for repair in 2-3 weeks. I said I don't know how you would repair a mold that was too large and believed it would have to be replaced. I asked for someone to look into it. They said they would when they had time.
This is not what I expected from Lee. I guess they must be very busy and I will need to be patient.
Not too cool to wait 3 weeks from Midway to get it and then another 3 weeks to get it fixed/replaced. Very frustrating.
KY
Last edited on Mon Oct 26th, 2009 09:43 PM by KY Hunter
|
