| Posted: Fri Jul 31st, 2009 10:56 PM |
|
1st Post |
miestro_jerry
Administrator
back to top
|
Some one made a target rack that would hold sporting clays for their grandson, could they contact me or report the pictures. I want to build one for my range.
Thanks,
Jerry
____________________
No Goats, No Glory
NRA Benefactor Member
Ohio Rifle and Pistol Association Member
The Cast Bullet Association
Bethesda Farmers and Sportsmen Club
ODNR Certified and Licensed Hunter
|
| Posted: Mon Oct 12th, 2009 03:57 AM |
|
2nd Post |
scooter58
member
| Joined: | Sat Sep 19th, 2009 |
| Location: | |
| Posts: | 14 |
| Photo: | | | Are you a handloader?: | Yes | | Favorite type of cartridge to load?: | I load everything! | | My favorite chambering is:: | any wildcats 17 ackley bee ... |
| Status: |
Offline
|
back to top
|
Hi There,
I made one which worked very well.
I made a stand from steel and welded a couple cross bars, one above the other.
In the bars I drilled two holes for each side of the clay . I then took copper wire and formed a loop about the outside width of the clay. To mount the clay, Take 2 loops, a clay and put the loops over each side of the clay. put the ends of the loop in the 2 holes that you drilled in the bars on each side of the clay.
_O__O___O__
!
--O-!---O-- O = Clay
!
_ !__
Sorry If I confused you but maybe the pic? will help.
Regards,
Scooter
|
| Posted: Mon Oct 12th, 2009 03:15 PM |
|
3rd Post |
miestro_jerry
Administrator
back to top
|
I have two pieces of wood that have slots routed in them, that will end up as my clay pigeon holders for my rifle range.
Plus I have two cases of clay pigeons just sitting sround waiting on me.
Jerry
____________________
No Goats, No Glory
NRA Benefactor Member
Ohio Rifle and Pistol Association Member
The Cast Bullet Association
Bethesda Farmers and Sportsmen Club
ODNR Certified and Licensed Hunter
|
|
